Doepfer

Module A-171-2 is a voltage controlled slew limiter with a lot of additional features beyond a simple slew limiter. It's mostly a licensed copy of Ken Stones VCS which is in turn based on the Serge VCS.These are the most important features:Manual control of the Slew-Up timeCV control of th..

Module A-171-4 is a fourfold voltage controlled slew limiter. It's intended purpose is polyphonic portamento but can be used also for other applications where several slew limiters are required. The common slew time can be adjusted manually and in addition controlled by an external control volt..

Manual Gate (Receiver)A-173-1/2 is a module combo that is used to generate a manually controlled 1V/Octave CV signal and up to 15 manually controlled gate/trigger signals. Typical applications are the transposition of a sequence by means of the CV output (without the need of an external keyboard and..

Joy Stick IIModule A-174-4 modules outputs three control voltages generated by a spring-loaded X/Y cross potentiometer (so-called joy stick) and a Gate signal. The control voltages for X and Y are controlled by the X and Y position of the joystick in the usual way. The third control voltage Z is con..

Theremin module for generating a variable control voltage by approaching/removing hand to/from an antenna. The distance range is about 30 cm. Additionally the module is equipped with a Gate output with adjustable threshold level. Controls/Inputs/Outputs: antenna input, offset (knob for zero adjust),..

Light Controlled Voltage Source II (Slim Line Series)Module A-179-2 can be used to convert different illumination intensities into corresponding analog voltages and a gate signal derived from the analog voltage. It's the successor of the obsolete module A-179.A light sensitive resistor (LDR) convert..

Modules A-180-1 and A-180-2 are simple multi-connectors. They have eight inter-connected sockets, so that you can "multiply" any audio or control signal. From the factory the modules come as two four-fold multiples. But they can be modified as an eight-fold multiple (solder bridge on the pcb). Thoug..

Module A-180-3 is a dual buffered 1-in-3 multiple. The signal applied to the input socket appears as a buffered signal at the three output sockets. Each output has it's own buffer, i.e. the three output sockets are not simply connected to each other. The lower output of the upper unit is normalled i..

OVERVIEWThe A-180-4 consists of four buffer circuits for control voltages. A buffer serves to avoid a voltage drop. This can occur due to different loads. The lower three units are each normalized to the previous output, so that the module can also be used as a buffered multiple by leaving the lower..

Multicore Signal ConnectorA-180-9 can be used to connect up to 14 audio or control signals between different cases using standard RJ45 network cables. It can be used to pre-patch different cases and connect common signals (e.g. clock, start/stop, master CV) using only one or two RJ45 cables instead ..