Noise Engineering Batverb

Batverb is the stereo reverb that dreams are made of: less of a room simulator and more of a tail generating pedal, Batverb is an instrument in its own right.

Taking inspiration from our popular tail-generating modules, Batverb brings reverberation and delay to a whole new level with extensive control of timbre, echoes, and dynamics. 

Start by setting a predelay time and adjusting Regen to set the length of the tail, from a short slapback-style echo to an infinite wall of reverberation.  A variety of unique controls make Batverb sing in any signal chain:

• Doom adds in chaotic suboctaves
• Shimmer brings in haunting overtones
• With each on its own control, go wild and have both at the same time!
• Low and high damping settings for the reverb tank
• Add filtering and harmonics to reverb tails
• Built-in saturation can apply to only the wet signal or the whole output
• Includes onboard dry/wet Blend control and input- and output-gain parameters
• Unique Duck switch controls the reverb’s behavior: duck out of the way of an input signal, or match the dynamics of your playing, similar to a gated reverb
• Create instant atmospheres with reverb-freezing Hold footswitch
• Route the expression input can to any parameter on the pedal
• Store and recall 16 different presets and recall them in response to MIDI program-change messages. 

Designed and built in sunny Southern California.

• Expansive reverb controls: go from short echoes to infinite tails
• Add filtering and harmonics to reverb tails
• Use Duck settings to make your reverb respond to your playing
• Create instant atmospheres with reverb-freezing Hold footswitch
• Full MIDI control
• Save and load 16 presets with MIDI Program Change
• Sounds great on guitar and synths
• Uses standard 2.1mm 9V negative-center power supply with minimum 250 mA